This module is designed to distribute audio signal to 10 locations. It features removable wiring
connectors, which allow you to pre-wire the system.
Specifications:
Power Handling: 200 watts RMS per channel maximum
Input wire: Up to 10ga
Output wire: Up to 14ga
Connection:
1.) Remove the green connectors. Loosen the set screws in each connector.
2.) Label all speaker wires.
3.) Observe correct polarity when connecting wires.
4.) Insert the wire into the connectors and tighten the set screws.
Module Installation:
1.) Place the module into the wiring enclosure.
2.) Position the module so that the tabs and hooks slip into the slots.
3.) Push black latch tabs into box to lock module.
4.) Push the green connectors onto the posts of the module.
5.) Install volume controls. NOTE: ONLY IMPEDANCE MATCHING VOLUME CONTROLS may be used with this
module. Use of resistive or other volume controls may damage your amplifier.
THIS MODULE IS DESIGNED FOR USE ONLY WITH IMPEDANCE MATCHING VOLUME CONTROLS.