This module will provide telephone distribution of up to 4 telephone lines and 8 telephones. This module also
provides a security interface for most security systems.
Module Installation:
1.) Place the module into the wiring enclosure.
2.) Position the module so that the tabs and hooks slip into the slots.
3.) Push black latch tabs into box to lock module.
Connection:
All connector terminals are "punch down 110" connections (except for the Security and Output Expansion).
*Please note that all connector blocks labeled "To Phones" are connected in parallel for each line.
1.) The twisted pairs should connected as follows: Blue=Line 1 Orange=Line 2 Green=Line 3 Brown=Line 4
2.) Connect the incoming lines to the "Source" connector. The connector will accept up to 4 lines. Each line is identified
1, 2, 3 & 4.
3. Connect the telephones to the module. Some telephones, depending on model, can accept multiple lines. Make the
appropriate connections to the punch down block for the number of lines your phone can accept.
For example: To connect Telephone 1 to line 1, punch down the Blue / White-Blue wire to the "To Phones"
connection block labeled "1" observing the color code. A 2-line phone would be connected the same way for line 1
and would also need the Orange / White-Orange wires punched down to the same connection block, again following
the color code.
Security Interface:
Turn the slide switch to the "ON" position and connect a jumper cable to the RJ-45 jack labeled " Security". Connect the
other end of the jumper cable to the security panel. To turn off the security function, unplug the cable and turn the switch
to "OFF".
Expansion:
Use the "Output Expansion" jack to link an additional phone distribution module to support 8 additional telephones.
